It is really vital to use extra caution when using a rough terrain scissor lift. Operators should be fully aware of the surrounding environment. Long booms on the machines act as levers from the center of the drive unit. For instance, a 6 inch bump could cause a 3 foot bounce when the operator is at the driver controls. Consider all other traffic nearby, because they might not be aware that you are moving. Plan your assent carefully. Park the boom lift on a flat surface that has no water or mud. These areas conceal deep potholes that can be possibly cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, completely extended. Be sure to only use approved wooden chalk blocks.
Some lifts would operate from the end of the boom on a metal platform. Long booms act levers on the drive unit. While you are at the driver controls, a 6-inch bump can result in a 3-foot bounce. Be aware of all other traffic. They may not know that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas can conceal deep potholes wherein the lift tires can fall, tipping the occupants. Extend all outriggers, if provided, completely. Place only approved wooden chalk blocks underneath the outrigger pads in order to prevent the unit from moving.
Overhead power lines are a serious hazard for lift drivers no matter what lift is being used. For example, if the operator of the platform is not being aware, or if the platform is being controlled by employees on the ground which is not able to accurately access proximity to wiring and hence, either the platform itself or the worker could be easily brought into contact with electrical wires. The worker could be electrocuted unfortunately unless properly insulated.