Most of the time, companies will spend lots of money to buy their forklifts. It is vital, therefore to take proper care of your machinery to protect your investment into the long run. It is a great idea to know the procedures that are undertaken during maintaining and taking care of this equipment.
Amongst the best ways to tell how good the engine is running is by starting the forklift up and listening carefully to see how it works. Like for instance, if there are any knocks or misses, the machinery is defective and this must raise several concerns. Moreover listen closely for any squealing noise that come from the belts because these noises will provide you with a lot of information.
When performing maintenance, several of the main components you will need to pay attention to consist of the safety warning devices, horn, gauges, the overhead guard and the lights. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also essential to check the wiring.
When the above parts have been inspected thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell must be inspected so as to make certain that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and after that change the filters. The transmission filter, fuel filters and the hydraulic filter must be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
Once the oil change has been completed and new filters have been fitted, visually check the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Check the belts on the engine for any frays or cracks. If you find any, fix the problem accordingly. Then, inspect every other component of the machine like the wheels. If any type of fault or issue is detected, be certain to address it immediately so as to make certain the machinery is running at its safest and optimum levels.